RefectoCil Brow Lamination Kit

Thanks to the RefectoCil Brow Lift eyebrow lamination procedure, the effect of perfectly shaped and lifted eyebrows lasts for a long time, while gaps caused by over-plucking are effectively concealed. Even unruly or very thick eyebrows can be laminated! The eyebrow lamination kit allows for 15 procedures, and with the new "Pink Power Perm" formula, processing time has been further reduced. Additionally, the product contains keratin, which strengthens the hairs.

Contents of the eyebrow lamination kit:

• 2 tubes of Lash & Brow Perm, 3.5 ml each;
• 2 tubes of Neutralizer, 3.5 ml each;
• 2 cosmetic applicators;
• 2 Rose Gold cosmetic bowls;
• 1 pack of Eye Care Pads.

Step-by-step brow lamination instructions:

1. Clean the eyebrows and surrounding skin with RefectoCil Micellar Eye Make-Up Remover. Then remove excess oils using RefectoCil Saline Solution. The skin and hairs should be thoroughly cleansed and dried. This ensures proper absorption of the product into the hair structure, achieving the desired lamination results.
2. Use the silicone brush from the Browista Toolkit to comb the brows and shape them as desired during lamination.
3. Apply Lash & Brow Perm (1) over the entire eyebrow, starting from the roots.
4. Continue applying in the direction of combing (following hair growth/upwards).
5. Avoid applying the product to the surrounding skin and work carefully. You can protect the skin with RefectoCil Skin Protection Cream & Eye Mask. If the product gets on the skin, remove it with a dry cotton pad. Leave Lash & Brow Perm for 6 minutes.
6. Remove Lash Perm (1) with a dry cosmetic stick or cotton pad, maintaining the same direction as the previous combing. Adjust individual hairs if necessary.
7. Apply the second product. Use a cosmetic brush to apply Neutralizer (2). Repeat step 3 and leave for 4 minutes.
8. Remove the Neutralizer (2) this time with a damp cotton pad, then wipe the eyebrow area with RefectoCil Saline Solution to fully remove all residues from the lamination process.
9. You can perform tinting during the lamination process. Apply RefectoCil henna to the brows (and lashes). Lamination reduces the processing time for tinting to 3 minutes!
10. After removing the henna, comb the brows again and shape them. Trim any overly long hairs if needed using eyebrow scissors.